Jump to content

Neal

Members
  • Content Count

    1863
  • Joined

  • Last visited

  • Days Won

    17

Everything posted by Neal

  1. Cheers for that. Just checked and have V1 version, phew These ones very manual rather offer style. Can be spoilt pinned as well
  2. Laughing as just found this thread again. Another fav band from the 80s
  3. Does the mk60 so much when the DSC is off ? Or is it a bit of a safety net. personally mk20 settings perfect for road and I tend to turn DSC off on the track as it retards second gear corner exits too much. Mdiff is quite fun on Taupo short track without the interference of DSC.
  4. Personally I’m pleased for the old owners to see a car that’s obviously been looked after and driven go for a leading market price. The only think I’d tyre kick is the front rotors and put them back to BMW spec ones next cycle. A very minor thing in the scheme of things.
  5. One of those LSB met its demise when it went from Wgtn to Auckland a few years back . Owner of the time struggled to get miid $30s. But it was another immaculate example . Yesterday’s price is what I paid for my M3 in 2011 when it had 48,000 km on the clock. Great to see the value coming back on theses and hopefully the same happens with the boring colours like mine.
  6. That would work if your not doing middle position. From memory the foam that sits on the parcel shelf and deck is pre cut. Would just need to lift the section out . It would be tight though. The isofix bracket sits in the foam section rectangle at the back in this picture the bracket has a claw that fits into a small hole and then uses a cap screw to fasten.
  7. I’ve done the retro fit on my e46 M3 a number of years ago. I originally brought the brackets of trademe but it was minus the covers. I ended up ordering the retrofit kit via BMW NZ dealer. install is straight forward. Worst part for me was carefully cutting the parcel shelf. Other than that it does take time to remove the rear parcel shelf on a e46. Rear seat side bolsters need removing and. C pillar trims and then top half of rear set before you can start removing the clips holding on the shelf . Then headrests and speaker covers
  8. Just seen this video on another thread .😬 Cringe worthy
  9. He did start with building the e46 / e39 connectors so worth an email. It might be possible that bmw carried the amp connector into the next models. Below is the harness / adapter btw , if looking at Morel check out parts-express. They sell the individual drivers with good discounts. Some models have great off axis response which is important on the drivers side speakers. https://www.parts-express.com/brand/morel/121
  10. for minimising speaker and HU cabling have a look at technics bmw harnesses . The guy reverse engineered the quad lock connector that sits in the amp . So basically his connector has rca and speaker wire hanging off it which means you can fit a small form factor amp in its place with minimal wiring effort so you can leave the cabin alone.. If your up for class D then heat is of little worry and 60wx4 rms will only need 8 gauge power and earth makking the battery run easy. The bmw e46 has a good gauge of wire on the mid bass speakers so no need to add fav 12 /14 gauge ofc. Sub,. As part of your research in terms of space . iB subs have come back to fashion and require minimal room . But also consider running passive radiators as the boxes end up small and there is no port noise. As a consideration iIm looking in a boom box project for the daughter using a Tan Ban w5 sub. Basically it only needs 20cm cube and can play down to the high 30hz. Q can be changed a bit by adding washers to its passive radiators . https://toidsdiyaudio.com/2020/02/06/mini-earthquake-an-8-cube-of-bass/
  11. Just doing a renewal on insurance for my E46 M3. It’s a 2002 SMG with almost every option and sits at 175k. It’s had BMW servicing since I brought i48k. Insurance company suggests $28k but I suspect it should be mid to high 30s What are others insuring theirE46 M3s for ?
  12. I think you’d be right , more hp and torque form the later especially and far more refinement. Issue with a daily is that Id end up with an m3 , a Motorsport project and a track day motorcycle limited edition motorcycle and probably would have to make some hard choices with parting with one of them. Not a bad problem to have but probably like many a classic bmw in great condition will come along and challenge status quo.
  13. I had conti sports contacts on the front of my e46 m3 . Size was 225 /45 R18 on a 8 inch front. On the e46 they had the best front steering and great feel. I’ve since run 235 fronts in Bridgestone re11 and Michelin PSS and whilst these have more grip the turn in and feel imho was better with the conti. Worth putting on your list and in 17inch friendly sizes
  14. I’m kinda caught, had a e46 m3 for last 9 years, no idea what I’d replace it with other than getting another low km one. I’ve deliberately avoided f80 m3s as suspect a drive would lead to a Mpulse decision to buy.
  15. Neal

    Quick Questions

    I ran yokos 509s in 195/65/14 on my e30 323i years back. They are an old design but were the best of the many tires I had in the 270,000 kms I drove it.
  16. It’s similar as in quadlock pin system but connector is larger and terminates with the boot. Dogballs post is on the money.
  17. Seems stuff via Asia is taking around 3 weeks. Ordered some essential service items for work with expedited shipping. We’d normal get this type of kit in 4-5 days. Different orders have taken 3 weeks. Part of the issue is NZ, some courier yards have become gridlocked with items beyond the warehouse and sitting in shipping containers waiting on the backlog to clear. NZ post has record volume levels as well. i think getting items quickly out of lockdown countries will be problematic for a while as with NZ returning to normal
  18. Sorry you did say you’d got the kenwood. Time alignment made a big difference in my system. Easier to centre music. With the kenwood what about running a USB ( if it has a rear one) to an ashtray dock) Location works well for hand free calls. Below if for iPhone but easy to put a phone cable instead https://www.instructables.com/id/Ashtray-iPhoneiPod-Dock/ amp mounting works well on the side of the boot. I’d be worried about underseat as I ran my alpine front amp that way. The power cable became shorted out by feet of rear passenger. There was a bit of smoke as a result. Since that I’ve only done boot installs and made sure power areas into amps are well protected. 4 gauge is good for a dangerous 120amps before a typical slow blow fuse will go.
  19. The early alpine stuff can easily overwhelm the factory alternator / electrics which is what I found with a multi amped setup in an e30.People are into 80/90s class ab nostalgia but I found that my old high end PG amps (e36 system) that the likes of modern sound stream ( Philip board actually) had similar sound quality at 1/3 red the price. Reminds me I still have my amps and equaliser from my late 80s system. Reminds me that I should sell these at some stage. Modern amps so much better, psu’s are far more efficient and they have every kind of protection and modern smd components means the old days of matching components is almost gone in relation to car audio. Anyway , this stuff is IMHO. I like your idea of running active up front. Just put a capacitor across the tweeter to protect it from accidents in tuning or setting crossovers. It the unit has speaker out only open it up and mod it. Grab the audio stage after the OPamps or preamp transistors and put some RCAs out the back . Should give you a cleaner audio section and get the best out of those tdk90s which from memory handed the heat better than maxwells and did a reasonable transfer. Speaker choice is a very personal thing and knowing your standards nothing really to add other than if I were to replace mine and one lotto I’d put Focal utopias into mine. With Angs CX-5 I’m looking to put https://stereointegrity.com/product/tm65-6-5-woofer/ and matching tweeter in. This brand is one guy who designs speakers with amazing mechanical abilities which punch well above there price tag and a few top end comp Hilfi cars are running these. Power wise looks like your heading to towards 4 gauge cables for the amp(s) Amp power on could be as simple as connecting to your power antenna . Just check the operation of the head unit to ensure antenna stays up in tape mode. This was the brand of distribution block that I showed you. Nice as small profile. Might have got mine via trade me. http://www.tspeconline.com/index.php?main_page=index&cPath=5 sub wise I’ve go a box calculator bass box pro so if you find the sub too boomy we could design a box with a bass q more to your liking. Could build something that bolts up to the ski pass area and punch out the panel. Bass will fire straight thought back seat cushion on e30s. other thing I did on my e30 was put the biggest battery that would fit in the front (mine was 323i) Other thing to consider is doing the big three which is to put a larger gauge alternator charging wire and bigger earth cable. Helps with electric stress and light dimming if pounding the system. For the rears speakersI run mine at -30db compared to front. I still feed mine with a 100rms but head unit ( warning , running head unit amp for rears can cause ground loops sometimes) or a micro class d amp. Sub wise go class D simply to give the car electrics an easier time. My current combo of 4x100 ab with 1x600d doesn’t kill the charging system and battery voltage in the way my 4x25rms (cough) PG amp with bridge rear channels run sub did. ( mind you that amp peaked at 95 amps at 13.8volts) so someone was lying about its modest power output.
  20. Neal

    Gull 98

    No , was 98 blend. The station concerned went back to selling 96
  21. Neal

    Gull 98

    The local Mobil did advertise the 98 as a ethanol blend. Was written on the pump. I think they sell both but I no longer use the brand.. i did try running my e46 m3 on it. It seem to engine knock more than normal 98 so I stopped using it. That was before I discovered the issue with the bike. ive since learnt that Ducati still recommend that you don’t use it on bikes. It was causing the plastic fuel tanks to bulge and swell. BMW saying ok to use after certain dates but I’ve lost trust in it. The good thing for myself was my bike no longer started which I thought was just stale fuel. I might have ended up with high pressure fuel being sprayed over my lower body and engine exhaust headers. Could have got very nasty quickly.
  22. Neal

    Gull 98

    Get it out now. Check all lines before using car in anger. Alternatively take it for a ride on guy fawkes
  23. Neal

    Gull 98

    Ran Mobil 98 in. Car and bike for a few years. Didnt ride the bike much and had in the tank too long. Tried to start bike ( Ducati 748r) no go. left it for a few months more and then got dealer to pick up. basically fuel lines had turned to a snot / marshmallow substance, fuel pump fckd , sender stuffed. Basically $1400 in parts. i won’t use ethanol blends again.
  24. Have driven a 320d sedan and 328i touring. I think you can’t go wrong with either, With the 320d I had a back to back timed slalom with my e46 m3. The result was .25 of a second faster in the 320d despite having 100kw less. The torque and less wheel spin was the key difference but was no slug. Not related to BMW , but my wife brought a cx5 2.2D turbo. We drove the company demos for 2.2d and NA 2.5. We used the demo cars actual fuel consumption figures and based ownership cost on those figures. Basically the 2.2D was close to $1000 cheaper per 10,000 kms to run. So 6.6 litres per 100km average for a1600kg suv with 800 km between with a 150km reserve. Im also a diesel convert. I’d love a 340d x3 next ?
×
×
  • Create New...